Ricoh Priport HQ7000 Operating Instructions Manual page 12

PostScript 3 - Setting Up for Printing
[PostScript] tab
Use this tab to make PostScript settings.
1
Note
❒ When this tab is displayed from the application's print dialog box, only [Post-
Script output format:] is displayed. To change the configuration of data format,
choose [Properties] from the [Printer] window, and then click the [Advanced...]
on the [PostScript] tab.
When you click [Advanced...] on the [PostScript] tab, you can set the following de-
tailed settings of PostScript:
❖ "ASCII data", "Binary communications protocol", "Tagged binary communications
protocol", "Pure binary data"
Select the data transmission protocol. When connected using the parallel inter-
face, select "ASCII data". An error may occur if other protocols are selected.
❖ "Send CTRL+D before job", "Send CTRL+D after job"
When using a network environment, clear both the "Send CTRL+D after job"
check box and the "Send CTRL+D before job" check box. When connected us-
ing a parallel interface, select the "Send CTRL+D after job" check box.
[Job Log] Tab
This tab is used to adjust the settings for plug-in modules. The plug-in modules
are modules that provide additional functions that cannot be implemented by
the printer driver or PPD file.
Limitation
❒ These functions cannot be accessed from an application that use its own print-
er driver, such as PageMaker, etc.
Note
❒ The settings adjusted using this tab remain in effect until the settings are ad-
justed again.
❖ [User ID:]
Enter the User ID to be displayed in Job History in SmartDeviceMonitor for
Client and SmartDeviceMonitor for Admin.
❖ [Print Job]
When select to "Store file", the print data is stored in HDD on the machine.
Note
❒ you can set the file name and the password to the data.
8