Cleaning The Automatic Density Control (Adc) Sensor - Dell 5100cn Owner's Manual

Cleaning the Automatic Density Control (ADC) Sensor

CAUTION:
INSTRUCTIONS" on page 9.
When the printer's automatic density control (ADC) sensor is dirty, follow the procedure below to
clean it.
Turn off the printer.
1.
Push the front latch up and fully open the front cover.
2.
Grip the tabs at both ends of the transfer roller and gently lift it out of the printer.
3.
56
Maintenance
Before performing any of the following procedures, read and follow the "CAUTION: SAFETY