Table of Contents
Advertisement
CARE AND CLEANING
(continued)
Coil Surface Unit Module
Clean the area surrounding
the surface
units
according
to either the Brushed Chrome or Porcelain
section (depending
on your model).
To clean the surface
units, turn the control to the
highest setting for a minute. The coils will burn off
any soil.
CAUTION
• Be sure all controls
are turned to OFF and
surface units are cool before attempting
to
remove
them.
• Do not immerse
the surface units or the module
in liquids of any kind.
• Do not clean the surface units or the module in
a dishwasher.
• Do not bend the surface unit plug terminals.
• Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
To remove a surface
unit:
Surface Unit
To remove the drip pans
for cleaning,
the surface
DripPan
units must be removed
,€ '/
first.
Lift the surface unit about
1-
1 inch above the drip pan
//
and pull it out.
Do not litl the surface
unit more than 1 inch.
If you do, it may not lie
flat on the drip pan when
you plug it back in.
Repeated
lilting of the surface
unit more than
1 inch above the drip pan can permanently
damage
the receptacle.
To replace
a surface
unit:
• Replace the drip pan into the recess in the cooktop.
Make sure the opening
in the pan lines up with the
receptacle.
• Insert the terminals
of the surface unit through the
opening
in the drip pan and into the receptacle.
• Guide the surface unit into place so it rests evenly.
Drip Pans
Remove
the surface units. Then lift out the drip pans.
For best results,
clean the drip pans by hand.
Place them in a covered
container
(or a plastic bag)
with 1/4 cup ammonia
to loosen the soil. Then scrub
with a soap-filled
scouring pad if necessary.
Rinse
with clean water and polish with a clean, soft cloth.
The drip pans may also be cleaned
in the dishwasher.
Do not cover the drip pans with foil.
Using foil so close to the receptacle
could cause
shock, fire or damage to the cooktop.
Clean the area under the drip pans
often.
Built-up
soil, especially
grease, may catch on fire.
Cleaning the Radiant Module
Normal
Daily Use Cleaning
ONLY use the recommended
cleaning
cream, Cerama Bryte ®, on the glass
surface. Other creams may not be
as effective.
To maintain and protect the surface of
your radiant module, follow these steps:
1. Before using tile radiant module
tbr tile first time, clean it with the
cooktop cleaning cream. This helps
protect the top and makes clean-up
easier.
Clean wmr
radiani
module
after each spill.
2. Daily use of the cooktop cleaning cream will help
keep the glass surface looking new.
3. Shake tile cleaning cream well. Apply a few drops of
the cream directly to the glass surface.
4. Use a paper towel or sponge to clean the entire
surface.
NOTE:
It is very important
that you DO NOT
heat the radiant module
until it has been cleaned
thoroughly.
26
Advertisement
Table of Contents
