Coil Surface Unit Module - GE JP389BJBB - 30" Electric Modular Cooktop Use And Care Manual

COIL SURFACE UNIT MODULE
How to Insert the Module
1. Be sure the controls are turned
to OFF. To install the module,
position the plug to the outside
wall of the cooktop.
2. Slide the module toward the
outlet in the side of the cooktop
until the plug is pushed all the
way in.
3. Lower the inside edge of the
module into the cooktop until
it is flush with the cooking
surface.
How to Remove the Module
1. Be sure the controls are turned to OFF and the
surface units are cool before attempting to remove
the module.
2. Lift up the tab at the inside edge of the module
until the base clears the opening at the side of
the cooktop.
3. To unplug, hold the module by the front and back
edges and slide toward the center of the cooktop.
Lift out when unplugged.
4. If you are storing modules, do not stack them or
store other materials on top of them. This could
damage the surface of the modules.
Cookware
Use medium- or heavy-weight cookware. Aluminum
cookware conducts heat faster than other metals.
Cast-iron and coated cast-iron cookware are slow
to absorb heat, but generally cook evenly at low to
medium heat settings. Steel pans may cook unevenly
if not combined with other metals.
For best cooking results pans should be fiat on the
bottom. Match the size of the saucepan to the size of
the surface unit. The pan should not extend over the
edge of the surface unit more than 1 inch.
Always read and follow cookware manufacturer's
instructions on cookware use.
Right Wrong
Not over 1 inch Over 1 inch
10