Windows XP:
1
Click Start→ Control Panel→ Add or Remove Programs→ Programs and Features.
2
Select the program you want to remove.
3
Click Uninstall.
4
See the program documentation for installation instructions.
Windows Vista:
1
Start
Click
2
Select the program you want to remove.
3
Click Uninstall.
4
See the program documentation for installation instructions.
drive letter : \
cannot read the disk. Insert a disk into the drive and try again.
N S E R T B O O T A B L E M E D I A
I
N
O N
-
S YS T E M D I S K E R R O R
restart your computer.
O T E N O U G H M E M O R Y O R R E S O U R C E S
N
A G A I N
— Close all windows and open the program that you want to use. In some
cases, you may have to restart your computer to restore computer resources. If so, run
the program that you want to use first.
O
P E R A T I N G S YS T E M N O T F O U N D
page 141).
IEEE 1394 Device Problems
CAUTION:
safety instructions in the Product Information Guide.
NOTE:
Your computer supports only IEEE 1394a standard.
E
N S U R E T H A T T H E C A B L E F O R T H E
T H E D E V I C E A N D I N T O T H E C O N N E C T O R O N T H E C O M P U T E R
E
N S U R E T H A T T H E
"System Setup Options" on page 79.
E
N S U R E T H A T T H E
Windows XP:
1
Click Start and click Control Panel.
2
Under Pick a Category, click Performance and Maintenance
→
Properties
104
Troubleshooting
→ Control Panel→ Programs→ Programs and Features.
I S N O T A C C E S S I B L E
— Insert a bootable floppy disk, CD, or DVD.
— Remove the floppy disk from the floppy drive and
— Contact Dell (see "Contacting Dell" on
Before you begin any of the procedures in this section, follow the
IEEE 1394
D E V I C E I S E N A B L E D I N S YS T E M S E T U P
IEEE 1394
D E V I C E I S R E C O G N I Z E D B Y
→
Hardware
Device Manager.
. T
H E D E V I C E I S N O T R E A D Y
L O S E S O M E P R O G R A M S A N D T R Y
. C
IEEE 1394
D E V I C E I S P R O P E R L Y I N S E R T E D I N T O
— The drive
— See
W
I N D O W S
—
→
→
System
System