Table of Contents
Advertisement
orb cyclone 73171M REV 1
3 Remove the top mesh
filter as shown I.
Gently brush the
mesh clean. The
pleated filter can be
gently knocked
against the side of the
dustbin to remove
excess dust.
To refit the filter, reassemble and locate
into the hole in the top of the dust container.
• The filter should be regularly washed
in cold water and left to air dry before
inserting back into the machine.
IMPORTANT: Do not use detergents to
clean the filter. The filter must be thoroughly
dry before the machine is used.
A spare filter is provided.
IMPORTANT: The dust container will not
lock back onto the machine unless the filter
is fitted correctly.
Pre-motor filter
An additional pre-motor filter is located
underneath the dust compartment lid. Lift
up the lid, the filter is located to the rear.
This should only require occasional
cleaning. Remove and shake rigorously to
clean.
30/7/04
11:36 AM
Cleaning the exhaust
filter
back of the product. To remove, press the
I
clip and pull the filter cover away from the
product. K Remove the filter.
by shaking over a dustbin. To remove fine
dust use the crevice tool brush to gently
clean between the pleats.
is replaced every 6 months or sooner if it
becomes damaged.
IMPORTANT
• All filters should be checked regularly for
J
• Always disconnect the cleaner from the
• Always make sure all filters are fitted
J
6
Page 6
The exhaust filter ‰ is located at the
The exhaust filter is non-washable. Clean
It is recommended that the exhaust filter
signs of damage, preferably after each
cleaning task. The filters must be
replaced immediately if they become
damaged.
mains when checking filters.
before use. Failure to do so may result in
damage to your product.
K
Advertisement
Table of Contents
