Pre-Motor Filter; Storage Position; Cleaning The Exhaust Filter - Morphy Richards ORB Pets Cyclone Manual

73174 rev4:73174 rev4 16/02/2009 15:53 Page 6

Pre-motor filter

An additional pre-motor filter is
located underneath the dust
compartment lid. Lift up the lid,
the filter is located to the rear I.
This should only require
occasional cleaning. Remove
and shake rigorously to clean.
Cleaning the exhaust
filter
The exhaust filter ‰ is located
at the back of the product. To
remove, press the clip and pull
the filter cover away from the
product J. Remove the filter.
The exhaust filter is
non-washable. Clean by shaking
over a dustbin. To remove fine
dust use the crevice tool brush
to gently clean between the
pleats.
It is recommended that the
exhaust filter is replaced every 6
months or sooner if it becomes
damaged.
IMPORTANT:
• All filters should be checked
regularly for signs of damage,
preferably after each cleaning
task. The filters must be
replaced immediately if they
become damaged.
• Always disconnect the cleaner
from the mains when checking
filters.
• Always make sure all filters are
fitted before use. Failure to do
so may result in damage to your
product.
UK Helpline 0844 871 0949
6

Storage position

When finished, you can store
the tubes and accessories by
locating the tube storage clip
into the slot on the bottom of
the cleaner as shown K.
Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119
I
J
K
6