Pre Motor Filter; Exhaust Filter; Technical Data - Morphy Richards 73106 Manual

• Always disconnect the cleaner from the
mains when checking or replacing the
filters.
• Always make sure the filters are fitted
correctly before use. Failure to do so may
result in damage to your product.

Pre Motor Filter

The pre-motor filter can be found by
25
opening the dust compartment
dust compartment release button
Remove pleated hepa filter
Remove the pre-motor foam filter
securing tabs and clean or replace.
Replace the foam filter
25
making sure it's located correctly. N

Exhaust Filter

The exhaust-filter must be cleaned
26
regularly to remove the fine dust particles
collected. This can be done by shaking it.
The exhaust filter is located behind the
exhaust filter covers . To remove, push
5
down on the tab and remove the cover. Pull
out the foam filter & clean or replace.
26
using the
4
6
and mesh filter.
22 23
from its
25
over the small tabs
O
7
Using the blower function
1 Remove the exhaust filter cover
foam exhaust filter
26
2 Push and twist clockwise P the blower
connector into the back of the cleaner
13
to lock into place.
3 Attach the hose to the correct end of the
8
blower connector
13
4 The blower function can be used for a
variety of uses including blowing dust from
delicate surfaces and also drying pet fur.
If using to dry pet fur:
• Never use the product in a wet
environment.
• Do not use if the animal is frightened
or distressed.
• Never leave the product alone with the
animal. Never allow the animal to chew
the product.

Technical Data

Power Supply : AC 230V 50Hz
Wattage : 800W
and
5
.