Tektronix AWG410 User Manual page 487

AWG410, AWG420 & AWG430 User Manual
www.valuetronics.com
Coupling . . . . . . . . . . . . . . . . . . . .
Slope . . . . . . . . . . . . . . . . . . . . . .
Level . . . . . . . . . . . . . . . . . . . . . .
Mode . . . . . . . . . . . . . . . . . . . . . .
d. Set the function generator (AFG310) controls.
Function . . . . . . . . . . . . . . . . . . . . . . . . Square
Mode . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous
Parameters . . . . . . . . . . . . . . . . . . . . . .
Frequency . . . . . . . . . . . . . . . . . .
Amplitude . . . . . . . . . . . . . . . . . . .
Offset . . . . . . . . . . . . . . . . . . . . . .
Output . . . . . . . . . . . . . . . . . . . . . . . . . On
2. Follow the substeps below to set the AWG400-Series controls and select the
waveform file:
a. Reset the instrument.
Push UTILITY (front-panel)!System (bottom)!Factory Reset
(side)!OK (side).
b. Load the MODE.WFM file.
Refer to Loading Files on page B–9 for file loading procedures.
c. Set the clock source to External.
H Push SETUP (front-panel)!Horizontal (bottom)!Clock Src
(side)!External.
3. Set CH1 output to enable.
Push the RUN (front-panel) and CH1 OUTPUT (front-panel).
The LEDs above the RUN button and CH1 OUTPUT are on.
Verify that the AWG output is running.
4. Verify that the output signal period is 100 ms.
5. Push CH1 OUTPUT (front-panel) to turn off the CH1 LED.
6. Push RUN (front-panel) to turn off the RUN LED.
7. Turn the function generator output off and disconnect the function generator
and oscilloscope.
Appendix B: Performance Verification
DC
Positive
+100 mV
Auto
10 MHz
0.7 V
p-p
0.5 V
B-77