Brakes - BMW R 1200 RT Rider's Manual

engine rpm for prolonged peri-
ods.
Try to do most of your rid-
ing during this initial period on
twisting, fairly hilly roads.
Comply with the rpm limits for
running in.
Running-in speeds
-1
<5500 min (Odometer
reading 0...200 km)
<6500 min -1 (Odometer
reading 200...400 km)
-1
<7500 min (Odometer
reading 400...600 km)
maximum engine rpm for
short bursts (Odometer
reading 600...900 km)
Do not omit the first inspection
after 500 - 1200 km.
Brake pads
New brake pads have to bed
down before they can achieve
their optimum friction levels. You
can compensate for this initial re-
duction in braking efficiency by
exerting greater pressure on the
levers.
New brake pads can ex-
tend stopping distance by a
significant margin.
Apply the brakes in good time.
Tyres
New tyres have a smooth sur-
face. This must be roughened by
riding in a restrained manner at
various heel angles until the tyres
are run in. This running in pro-
cedure is essential if the tyres are
to achieve maximum grip.
Tyres do not have their full
grip when new and there
is a risk of accidents at extreme
angles of heel.
Avoid extreme angles of heel.

Brakes

How can stopping
distance be minimised?
Each time the brakes are applied,
a load distribution shift takes
place with the load shifting for-
ward from the rear to the front
wheel. The sharper the motor-
cycle decelerates, the more load
is shifted to the front wheel. The
higher the wheel load, the more
braking force can be transmitted
without the wheel locking.
To optimise stopping distance,
apply the front brakes rapidly and
keep on increasing the force you
apply to the brake lever. This
makes the best possible use
of the dynamic increase in load
at the front wheel. Remember
to pull the clutch at the same
time. In the "panic braking situ-
ations" that are trained so fre-
quently braking force is applied
5
85
z