BMW R 1200 RT Rider's Manual page 127

Rear wheel to wheel car-
rier
Tightening sequence: tight-
en in diagonally opposite
sequence
60 Nm
Push the end silencer onto the
pipe at the exhaust-flow control
valve and turn it to its initial
position.
If the gap between the rear
wheel and the silencer is
too small, the rear wheel can
overheat.
The gap between the rear wheel
and the silencer must be at least
20 mm.
Align the silencer, install
screw 2 and tighten to the
specified torque.
Silencer to rear frame
19 Nm
Slip the clamp forward as far as
it will go and turn it so that R/
RT mark 4 on the clamp is in
line with mark 5.
Tighten screw 1 to the spe-
cified tightening torque.
Clamp to silencer and
manifold
28 Nm
If applicable, install the cases.
8
123
z