BMW HP2 SPORT Rider's Manual page 82

5
78
Slacken screws 1 at left and
right sliding tubes.
Slacken screws 2 at the front
z
mudguard.
Using a suitable lifter, raise the
motorcycle until the front wheel
is clear of the ground. BMW
Motorrad recommends the
BMW Motorrad middle stand.
Install the middle stand
( 138)
Adjust the forks to the desired
height by repositioning the slid-
ing tubes in the fork bridge
within range of adjustment a.
Make sure that the tubes are
not moved past highest per-
missible position 3.
Motorcycle height, front
max 15 mm (Range of
adjustment between bottom
edge of fork slider tube
bridge and stop on slider
tube)
To restore the factory setting:
push the sliding tubes all the
way up.
If the sliding tubes are diffi-
cult to move in the fork bridge:
slacken axle clamping screw 4.
Slacken quick-release axle 5.
Adjust the height of the forks
as described above.