BMW HP2 SPORT Rider's Manual page 75

load-dependent adjust-
ment of spring preload
33 mm (Negative spring dis-
placement of front wheel
under load)
If you want to reduce the dif-
ference (increase spring pre-
load, in other words), turn ad-
justing ring 2 in direction c.
If you want to increase the dif-
ference (reduce spring preload,
in other words), turn adjusting
ring 2 in direction b.
Tighten the lock by tightening
adjusting ring 1 in direction c
with the tool from the toolkit,
while holding adjusting ring 2
with the second tool from the
toolkit.
Locknut for spring basic
setting to spring retainer
5 Nm
Adjust the damping character-
istic to suit spring preload.
Hold the air intake pipe in posi-
tion.
Push in both retainers 2 until
they engage with an audible
click.
Check that the throttle-valve
cable is seated in guide 3 of
the intake and that the throttle
valve is seated against the
stop.
5
71
z