BMW HP2 ENDURO Maintenance Instructions Manual page 31

Check for wear at the
insides of left and right
telescopic-fork protectors 1
and check left and right
slip-rings 2 for wear.
If evidence of wear is visible:
Have the condition of the
telescopic-fork protectors
and the slip-rings checked
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.
Bleeding telescopic forks
Make sure the ground is
level and firm and place the
motorcycle on its stand.
Back off and then retighten
screw 1 on the left in the
fork bridge.
Back off and then retighten
screw 1 on the right in the
fork bridge.
Checking ease of move-
ment of side stand
Place the motorcycle on the
auxiliary stand (see Rider's
Manual).
Extend and retract the side
stand to check the freedom
of its movement.
If the side stand is stiff:
Have the side stand
checked by a specialist
workshop, preferably an
authorised BMW Motorrad
dealer.
Check operation of side-
stand switch
Switch off the engine and
extend the side stand.
With the clutch disengaged,
switch on the ignition and
start the engine.
The engine starts.
Engage first gear.
The engine cuts out.
4
27
z