BMW HP2 ENDURO Maintenance Instructions Manual page 20

3
16
Position holders 3 in such
a way that the cables pass
through recess 4. Note the
identifying marks RK for the
right hand protector and LK
for the left hand protector.
Install screws 5, but do not
tighten them at this point.
z
Use screws 6 and
washers to secure the
hand-protector holder to
the hand protector. Use
hand-protector holder
7 684 575 for the left side
and 7 684 576 for the right
side.
Hand protector to holder for
hand protector
3 Nm
Use screw 7 and washer to
secure the hand-protector
holder to the mirror clamp-
ing block.
Holder for hand protector to
mirror clamping block
3 Nm
Use screw 8 and washer to
secure the hand protector
to holder 3.
Hand protector to clamping
block
3 Nm
Tighten screws 5 of the
holder in such a way that
the gap between the top
and bottom halves of the