Eaton Mariner 70-8641 Installation Instructions

Installation Instructions for Mariner Light Bollard (#70-8641)
Hazardous voltage. Can cause severe in-
jury or death.
Turn off main power before opening panel.
Eaton Electrical Inc. strongly recommends that these
products be installed by a qualified electrician.
IMPORTANT - INSTALL EQUIPMENT IN CONFORMANCE
WITH CODES
This product must be installed in accordance with the National
Electric Code (NEC) or the Canadian Electrical Code (CEC0 and
any applicable local codes. Before installing equipment, check
with your local electrical inspector for requirements and infor-
mation. If you have questions or need assistance, contact a
qualified electrician.
Turn off or disconnect the power supplying this
equipment before beginning work.
This may require that you contact your electric utility to
disconnect power to an existing load-center. The line
side of the main breaker is energized unless power is
disconnected upstream. Eaton Electrical, Inc. will not
assume responsibility for property damage or personal
injury resulting from misuse of the information in this
publication.