Download Print this page
Kingfisher 9600 Quick Reference Manual
Kingfisher 9600 Quick Reference Manual

Kingfisher 9600 Quick Reference Manual

Optical power meter

Advertisement

Quick Links

Quick Reference Guide – 9600 Optical Power Meter
• To remove interchangeable connector adaptor, press
the button on the front of the instrument and pull off
adaptor.
• To defeat auto power-off, press and hold [POWER] for
3 seconds during turn on. 'Perm' is displayed on the top
right of the LCD.
• Low battery is indicated with a battery symbol.
• During instrument turn on:
- to view all display segments, press and hold []
- to turn buzzer off, press and hold []
- to display firmware version, press and hold
[HOLD]
- to start Slow mode, press and hold [dB/dBm/mW
Set Ref]
• To scroll wavelength, press [] or [].
• To toggle logarithmic/relative/linear display modes,
press [dB/dBm/mW].
• To stop / start display update, press [HOLD].
OPT152 Rev12
• To set reference, press and hold [Set Ref] for more
than 3 sec or until beeping stops. When in reference
mode, the reference value is shown on the left-hand
side of the display.
• To display max min recorded power, press and hold
[Max Min] in turn. To re-set this function, press
[POWER].
• When multi-fibre ID tone is detected by a power
meter, a buzzer will sound, and the corresponding
fiber ID number will be displayed. This function is
disabled in Slow Mode.
• When a standard tone is detected (e.g. 270 Hz, 330
Hz [for FW1.00 or above],1 KHz, 2 KHz), a buzzer will
sound, and the corresponding modulation frequency
will be displaye
.
d
• If the meter detects a test tone higher than 200 Hz,
the display will show the actual measured modulation
frequency in kHz. This function is disabled in Slow
Mode.
Page 1 of 3

Advertisement

loading
Need help?

Need help?

Do you have a question about the 9600 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kingfisher 9600

  • Page 1 Quick Reference Guide – 9600 Optical Power Meter • To remove interchangeable connector adaptor, press • To set reference, press and hold [Set Ref] for more the button on the front of the instrument and pull off than 3 sec or until beeping stops. When in reference adaptor.
  • Page 2 Quick Reference Guide – 9600 Optical Power Meter Slow Mode: TamperLock Mode: • In Slow Mode, the display will show average optical • While in TamperLock Mode, user is prevented from power of the modulated signal. All tone detection is changing wavelength, dB/dBm/mW, Hold, min max and disabled.
  • Page 3 Quick Reference Guide – 9600 Optical Power Meter In case where entered sequence was not correct, Press [] or [] to select the wavelength for “FAIL x” will be displayed (where x is attempted count). display. To resume display-scrolling, press [HOLD] and [] TamperLock will be cleared after three unsuccessful at the same time.