Bionaire BFH912 Instruction Manual page 3

• Clean the air inlet and outlet openings
regularly (with normal use at least twice a
year) with a vacuum cleaner.
FOR U.K. AND IRELAND ONLY
If the plug is not suitable for the socket outlets
in your home, it can be removed and replaced
by a plug of the correct type. Please refer to
"Installation of a plug" below.
Installation of a plug applicable to U.K.
and Ireland only
NOTE: If the terminals in the plug are not
marked or if you are unsure or in doubt about the
installation of the plug please contact a qualifi ed
electrician.
If a 13A 3-pin plug is fi tted, it must be an ASTA
approved plug, conforming to BS1363 standard.
Replacement 13A fuses must be BSI or ASTA
BS1362 approved.
This product is fi tted with a 13A plug complying to
BS1363. If this plug is unsuitable or needs to be
replaced, please note the following: The wires in
the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug. Please
proceed as follows:
The BROWN coloured wire must be connected to
the terminal, which is marked with the letter "L" or
is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
DO NOT CONNECT either of these wires to the
earth terminal in the plug. The earth terminal plug
is marked with the letter "E", or with the earth
symbol , or coloured GREEN, or GREEN and
YELLOW.
BFH912-I_09MLM1.indd 7-8 BFH912-I_09MLM1.indd 7-8
GUARANTEE
Please keep your receipt as this will be required
for any claims under this guarantee.
This appliance is guaranteed for 2 years after
your purchase as described in this document.
During this guaranteed period, if in the unlikely
event the appliance no longer functions due to a
design or manufacturing fault, please take it back
to the place of purchase, with your till receipt and
a copy of this guarantee.
The rights and benefi ts under this guarantee
are additional to your statutory rights, which are
not affected by this guarantee. Only Holmes
Products (Europe) Ltd. ("Holmes") has the right
to change these terms.
Holmes undertakes within the guarantee period
to repair or replace the appliance, or any part of
appliance found to be not working properly free
of charge provided that:
• you promptly notify the place of purchase or
Holmes of the problem; and
• the appliance has not been altered in any
way or subjected to damage, misuse, abuse,
repair or alteration by a person other than a
person authorised by Holmes.
Faults that occur through, improper use, damage,
abuse, use with incorrect voltage, acts of
nature, events beyond the control of Holmes,
repair or alteration by a person other than a
person authorised by Holmes or failure to follow
instructions for use are not covered by this
guarantee. Additionally, normal wear and tear,
including, but not limited to, minor discoloration
and scratches are not covered by this guarantee.
The rights under this guarantee shall only apply
to the original purchaser and shall not extend to
commercial or communal use.
If your appliance includes a country-specifi c
guarantee or warranty insert please refer to
the terms and conditions of such guarantee or
warranty in place of this guarantee or contact
your local authorized dealer for more information.
Waste electrical products
should not be disposed
of with Household waste.
Please recycle where
facilities exist. E-mail us at
enquiriesEurope@jardencs.
com for further recycling and
WEEE information.
Holmes Products (Europe)
Limited
1 Francis Grove
London
SW19 4DT
UK
4
Troubleshooting for your Heater
Trouble Probable Cause
• Heater Does ☛ Manual user reset is activated.
Not Turn On.
☛ Timer Activated.
☛ Not plugged in properly.
☛ Electrical outlet does not hold
plug in securely.
☛ Thermostat set too low.
☛ Obstruction causing the heater
not to operate.
• Power Light ☛ Auto Safety Shut off system
Is Flashing is activated when there is
or in some potential overheat.
cases,
Heater Turns
On at HIGH
Heat (2)
setting but
then Shuts
Off in 2
seconds with
Power Light
Flashing.
• Not Enough ☛ Heater is in Low Heat or 1
Heat. setting.
☛ Thermostat set to low.
• Heater ☛ The thermostat automatically
Cycles ON turns the heater on and off
And OFF to maintain selected comfort
Frequently. level.
• Heater Is ☛ Unit is set to Fan Only setting.
Blowing Cold
Air.
☛ When the heater is in
thermostat mode and reaches
the set temperature it will
autmocatically perofrm a 15
second cool down (blowing
cold air) to ensure thermostat
accuracy.
☛ Power Button may have been
pressed to turn off the heater.
Solution
✔ Follow reset instructions listed in this
manual.
✔ Press the Power Button to turn on the
heater.
✔ Ensure plug is properly inserted. Make
sure electrical outlet and circuit breaker
are working.
✔ Have outlet replaced by a licensed
electrician.
✔ Turn the Dial Wheel (+) to the highest
temperature setting.
✔ Unplug the heater and remove all
obstructions. Position your heater
at least 50cm away from obejcts for
the top, back and sides and at least
200cm distance away from objects for
the front grill.
✔ Follow Auto Safety Shut Off
instructions to reset the heater and
allow suffi cient time for the heater to
cool down before plugging in again.
✔ Change setting to 2 (HIGH) heat.
✔ Turn the Dial Wheel (+) to the highest
temperature setting.
✔ To make this occur less frequently
turn the Dial Wheel (+) to the highest
setting.
✔ Press the 1 (LOW) or 2 (HIGH) heat
setting button.
✔ Raise the temperature higher or
change setting to 2 (HIGH) heat.
✔ Press the Power Button to turn on the
heater.
5
5/11/09 9:07:51 AM 5/11/09 9:07:51 AM