Miniatures Corner Shop Kit Step By Step Assembly Instructions

#9991 Corner Shop Kit
Step-by-step assembly instructions
Copyright miniatures.com 2013, 2024
PARTS LIST:
Corner Wall With Door
Left Wall With Bay Window
Right Wall With Bay Window
Left Back Wall
Right Back Wall
Base
Grooved Trim for top (5)
Plexi Glass for top
Corner Top Facade
Side Top Facade (2)
Oval Trim
Large Plexi for Bay Window (2)
Narrow Plexi for Bay Window (4)
SUPPLIES NEEDED:
Masking tape
White glue (such as #1249 Weldbond)
Damp clean cloth
Exterior and interior finishes
Assembly Instructions
1. Follow the assembly exploded design looking at each
piece from the outside. Use the base as a guide to place
shop on during assembly but do not glue in place at
this time.
2. Glue the right end of Left Back Wall (narrow trim piece at
top to the inside and wider trim at bottom on outside) into
the groove on the back of the left side of Left Wall With
Bay Window. Be sure bottom and top edges of walls are
flush. Secure with pieces of masking tape. Allow to dry.
3. Glue the left side of Left Back Wall into groove and angle
trim on right side of Right Back Wall (narrow trim at top
on the inside with wider trim at bottom and angle corner
on the outside). Be sure bottom and top edges of walls are
flush. Secure with masking tape. Allow to dry.
4. Glue the left side of Right Back Wall into groove on the
back of right side of Right Wall With Bay Window. Flush at
top and bottom. Secure with masking tape. Allow to dry.
5. With this part of assembly setting loose on the base, be
sure the corners are square.
6. Glue the right side of Left Wall With Bay Window into
the groove on the left side of Corner Wall With Door and
2388 Pleasantdale Road, Atlanta, GA 30340 • 1.800.926.6464 • www.miniatures.com • Made in Thailand
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts List and Parts Diagram.
• Thoroughly read the directions before starting.
• Set up a dedicated work area to avoid the need to unpack,
repack, or move the project frequently.
• Use a clean, level, and dry work surface protected from glue spills.
• Dry fit the parts using masking tape to ensure everything aligns
correctly before permanent assembly.
Tips:
•
Remove paper from plexiglass before installing in the
front windows.
•
Remember, it is easier to work on the individual walls
on your work table before assembling the shop.
•
Suggested Finishing Techniques BEFORE Construction:
•
Stain or Paint walls, facade and trims before assem-
bling the store.
•
Apply any outside finish, such as: Brick or Clapboard.
•
Decide how you are going to finish the inside of
the store ; the walls, electrify the store, hard wire
or tape wire?
•
Fit and match wallpaper, wainscoting, paneling, etc.
to inside of walls and apply.
•
The plexiglass included for the front windows can
be used clear or made into "stained glass" windows.
(See "stained glass" windows in "Everything You
Wanted To Know About Dollhouses But Didn't Know
Who To Ask" instruction book.) Glue the plexiglass
into the windows. Be careful to only put glue on the
edges. "Stained glass" windows should be finished
before gluing in place.
•
Fit any window treatments and secure in place.
•
Glue hardware on door.
•
If Framed Plexiglass Top is not assembled, fit the
four pieces of grooved trim around large piece of
plexiglass and glue at joints. Do not get glue on vis-
ible area of plexiglass. Secure with masking tape
and allow to dry.
WARNING:
Not Suitable for Children
under 15 years old.
CHOKING HAZARD — Small parts
0824