Miniatures Conservatory Dollhouse Kit Step By Step Assembly Instructions

#9900 Conservatory Dollhouse Kit
Step-by-step assembly instructions
Copyright miniatures.com 2025
SUPPLIES NEEDED:
Masking tape
White glue (such as #1249 Weldbond)
Damp clean cloth
Exterior and interior finishes
Glossy " wide tape (not gift wrap tape)
/
3
4
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts Diagram.
• Read the directions completely before beginning
the project.
• If possible, have a dedicated work area so that you are
not unpacking, repacking, and moving the project from
place to place.
• Choose a work surface that is level, clean, dry, and
protected from spills.
• Do a dry fit, using masking tape to hold parts in place,
to make sure everything fits together correctly before
assembling permanently.
Assembly Instructions
Walls
Parts you will need in this section:
• Floor
• Front Wall
• Left Side Wall
• Right Side Wall
• Front Wall Cap
• Side Wall Cap (2)
• Window Acrylic Small (6)
• Window Acrylic Large (2)
Glue the Side Walls to the Front Wall.
1.
• Orient the walls so that their detailed trim is facing out
and their plain trim is facing in.
• The grooves on the Front Wall receive the tabs of the
Side Walls.
2. Glue the Floor in place.
• It slides into the space between the Side Walls and
against the Front Wall. It rests on the work surface and
touches the inside surfaces of the walls.
3. Glue the Front Wall Cap to the top of the Front Wall.
• Orient it so that its notches face towards the back. It is
flush with the trim and corners of the wall.
2388 Pleasantdale Road, Atlanta, GA 30340 • 1.800.926.6464 • www.miniatures.com • Made in Thailand
Not Suitable for Children
under 15 years old.
Tips: Plan the finishes for the interior and exterior at the
dry-fit stage, before final/permanent assembly. It is easier
to finish the panels as flat surfaces. Disassemble and
finish as desired, then reassemble using glue.
Before painting, staining or otherwise finishing the walls,
remove the windows from their wall openings and the
muntins and acrylic from both doors. The muntins are held
in place by tension and small pieces of tape. Gently push
the acrylic up and out of the wooden door frames; the top
of the frame will come loose.
4. Glue both
Side Wall
Caps to the
tops of the
Side Walls.
• They meet the notch of
the Front Wall Cap and are
flush at the back edge and along the trim of the wall.
5. Square the assembly and let dry.
6. Add acrylic to the windows and return the windows into
their openings. Return the acrylic and muntins into the
door frames.
WARNING:
CHOKING HAZARD — Small parts
0225