Miniatures Coffee Spot Kit Step By Step Assembly Instructions

#14418 Coffee Spot Kit
Step-by-step assembly instructions
Copyright miniatures.com 2024
PARTS LIST:
Platform Base (2)
Platform Short Side (2)
Platform Long Side (2)
Building Front
Building Walls (2)
Building Ceiling
Building Roof
Building Front Shelf
Building Side Trim (2)
Building Bottom Trim
Building Top Trim
Counter Top/Bottom (2)
Counter Walls (3)
Counter Shelves (2)
Assembly Instructions
PLATFORM
Parts you will need:
• Platform Base (2)
• Platform Short Side (2)
• Platform Long Side (2)
BUILDING
Parts you will need:
• Building Front
• Building Walls (2)
• Building Ceiling
• Building Roof
• Building Front Shelf
• Building Side Trim (2)
• Building Bottom Trim
• Building Top Trim
2388 Pleasantdale Road, Atlanta, GA 30340 • 1.800.926.6464 • www.miniatures.com
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts List.
• Thoroughly read the directions before starting.
• Set up a dedicated work area to avoid the need to unpack,
• Use a clean, level, and dry work surface protected from glue spills.
• Dry fit the parts using masking tape to ensure everything aligns
Place the Base flat on the work surface.
1.
2. Glue the two Short Sides to the
Base on opposite sides.
3. Glue the two Long Sides to the
Base on opposite sides. Corners
are flush.
4. Glue the other Base to the top
of the assembly.
5. Set aside and let dry.
6. Place the Front flat on the work surface.
7. Glue both Walls and the Ceiling to the front
to form a box.
8. Let the glue set for a few minutes.
9. Stand the assembly upright.
10. Glue the Front Shelf into the window opening.
11 Glue both Side Trims to the exterior side walls.
All edges are flush. Notice that the smaller
rectangles are towards the bottom.
12 Glue the Bottom Trim on the front below the
Front Shelf. All sides are flush.
13. Glue the Top Trim on the front above the
Front Shelf. All sides are flush.
14. Glue the Roof in place. It is flush at the back
and overhangs at the front.
Not Suitable for Children
under 15 years old.
repack, or move the project frequently.
correctly before permanent assembly.
WARNING:
CHOKING HAZARD — Small parts
TSCA TITLE VI
Compliant
0824