KeeNetic HOPPER KN-3811 Quick Start Manual

KEENETIC
HOPPER
Quick Start Guide
AX3000 Mesh Wi-Fi 6 Gigabit Router
with a 4-Port Gigabit Smart Switch
and USB 3.0 Port
Model: KN-3811
Installing Your Keenetic Hopper
1. Position your Keenetic Hopper (hereinafter 'Keenetic device') within
cable lengths of Ethernet and power outlets. Place your Keenetic
device in an unenclosed space for better wireless coverage. Connect
your Keenetic device to a power source. Check that both the
Status LED C and Wi-Fi LED D are illuminated and not blinking.
2. Сonnect a mobile device to your Keenetic device via Wi-Fi. The default
Wi-Fi name (SSID) and the Wi-Fi password are printed on your Keenetic
device's back label along with a QR code that will automatically
connect your mobile device to the Keenetic device's Wi-Fi when
scanned. Alternatively, сonnect a computer to the gray Ethernet port
on your Keenetic device using the included Ethernet cable.
3. Once connected, an Initial Setup Wizard window will appear on your
mobile device / computer. If the Wizard does not appear, using a browser
go to my.keenetic.net and follow the setup instructions.
Note: If the Initial Setup Wizard still doesn't appear, please refer
to the Frequently Asked Questions section below.
For technical support and other information,
please visit
support.keenetic.com
1
2
10:00
Welcome
to the Initial
Setup Wizard
Run wizard
3