Advertisement
Quick Links
Advertisement
Related Manuals for KeeNetic Ultra KN-1810
Summary of Contents for KeeNetic Ultra KN-1810
- Page 1 User Guide Learn more about the features of your Keenetic at help.keenetic.com...
- Page 2 10 seconds until the indicator and used to connect to the Internet. The starts flashing. The Keenetic will reboot with the indicators located above the ports light up default settings, in the main operation mode. when a connection is established for the...
- Page 3 Combo port "0" Indicator (Status) Port for Internet connection, combining On — the Keenetic is ready for operation. a RJ-45 connector for Ethernet cable and Off — the Keenetic is turned off. a SFP slot for a fiber optic connection via SFP module (sold separately).
- Page 4 USB 3.0 or USB 2.0 interface. The ports are located on the On — the Wi-Fi network is enabled. side of the Keenetic; the high-speed USB 3.0 port is marked "1" and is colored in blue. Off — the Wi-Fi network is disabled.
- Page 5 You are about to set up web browser or scan the QR code located the Keenetic in just a few steps, and then on this page with your mobile device. you will be able to manage your home network even remotely via the Internet.
- Page 6 Ethernet cable or fiber optic cable Connect the Ethernet cable from your ISP to the of the Keenetic during connection setup. "0" port on the Keenetic. If the contract with your To connect via a fiber optic line, broadband provider specifies a MAC address...
-
Page 7: Connecting To Internet
Keenetic using a network cable. connecting via a leased Ethernet line. In order to use all the features of the Keenetic, You can use the connection via DSL or GPON as the modem must be in bridge mode. If the your primary Internet connection or as a backup... - Page 8 USB modem. Place it near a window and Connect the modem with installed SIM card make sure there are no obstacles between the to the USB port of the Keenetic. When the modem and the window, to avoid weakening modem is ready for operation, the FN indicator the network signal.
-
Page 9: Recommendations For Safe Use
Remove all protective film before operating the ⬛ device. Never open the Keenetic or its power adapter ⬛ and never try to service them on your own. If you In the course of the operation, the device heats ⬛... - Page 10 WPA2 AES security (enabled follow these guidelines: by default). If you select WEP or WPA protection, maximum Wi-Fi speed will be reduced to 54 Install the Keenetic in a room where you want to ⬛ Mbps. ensure the fastest wireless connection. Concrete Install updates for all your wireless devices and walls greatly reduce the network speed.
-
Page 11: Information And Support
Power on the Keenetic, wait for it to power up, ⬛ that cannot connect to the Internet. Check then turn on the other devices. -
Page 12: Warranty
Keenetic Limited is not responsible of product service tag automatic registration for loss or corruption of data stored in the Keenetic Support Center log at the on storage devices connected to the device’s first connection to the Internet, or the Keenetics. - Page 13 When you first connect to the 50/60Hz Internet the service tag is automatically recorded Ethernet cable ⬛ in the Keenetic Support Center log. By using the User Guide ⬛ Keenetic Ultra, you agree with right of Keenetic Limited to automatically receive information...
- Page 14 Simplified EU declaration of conformity © Keenetic Limited, 2018. All rights reserved. Keenetic Limited hereby declares that this device Reproduction, adaptation, translation, or is in compliance with Directive 2014/53/EU. distribution of this document or any part thereof The full text of the EU declaration of conformity...