Installation; Unpack And Inspect The Product; Move The Product - Fluke 9500C User Manual

9500C
Users Manual
Current loop
output adapter
Head Carry Case
Rack Mounting Kit

Installation

Use this section to unpack and install the Product.

Unpack and Inspect the Product

Carefully unpack the equipment and check for external damage to the case, sockets, controls,
and other parts of the Product.
If the shipping container and cushioning material are not damaged, keep the packing for

use in subsequent shipments.
If you notice damage, keep the shipping container, inner carton, and cushioning material

for inspection by the carrier. Notify the carrier immediately.
Standard accessories supplied with the Product are described in
note.

Move the Product

To avoid injury, take special care when lifting and carrying the Product. The
Product weighs >12 kg.
Place product on a flat stable surface. Do not place product where vents are covered. Do not
place product where access to the mains power cord is blocked.
To lift and carry from bench height:
1. Disconnect and remove any cables from the Product.
2. Disconnect Active Heads from the front panel.
3. Tilt the Product so the Product stands vertically on the rear panel, with the feet towards
you, at the edge of the bench.
The center of gravity for the Product is concentrated at the rear.
4. Grasp the Product at the bottom (rear panel) corner furthest away from you, and tilt the
Product slightly to rest against you.
5. Take the weight and carry the Product vertically at the same height, making sure the
Product remains resting against you.
4
Table 1. Options and Accessories (cont.)
Part
Adapter that can be fitted to the Active Head output to
3127944
calibrate current probes.
Case to store and transport up to 5 Active Heads and
6000074
cables.
5341848 Kit used to mount the Product into a rack or cabinet.
XW Warning
Description
Table 1 and on your delivery