Ieee 1394 Device Problems - Dell 5160 Owner's Manual

— The hard drive cannot read the data. See "Drive Problems" on page 57.
D A T A E R R O R
T H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E
to copy is too large to fit on the disk, or the disk is too full. Try copying the file to a different disk or use
a larger capacity disk.
F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
A
use these characters in filenames.
I N S E R T B O O T A B L E M E D I A
a CD.
N O T E N O U G H M E M O R Y O R R E S O U R C E S
many programs open. Close all windows and open the program that you want to use.
O P E R A T I N G S YS T E M N O T F O U N D
contact Dell (see page 101).
R E Q U I R E D F I L E W A S N O T F O U N D
A . D L L
essential file. Remove and then reinstall the program.
1
Click the Start button and click Control Panel.
2
Click Add or Remove Programs.
3
Select the program you want to remove.
4
Click Remove or Change/Remove and follow the prompts on the screen.
5
See the program documentation for installation instructions.
X : \ I S N O T A C C E S S I B L E

IEEE 1394 Device Problems

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
E N S U R E T H A T T H E IEEE 1394
— The operating system is trying to boot to a nonbootable CD. Insert
. E X I T S O M E P R O G R A M S A N D T R Y A G A I N
— Reinstall the hard drive (see page 81). If the problem persists,
— The program that you are trying to open is missing an
. T H E D E V I C E I S N O T R E A D Y
D E V I C E I S P R O P E R L Y I N S E R T E D I N T O T H E C O N N E C T O R
— The file that you are trying
: \ / : * ? " < > | — Do not
— Insert a disk into the drive and try again.
— You have too
Solving Problems
61