Tuner Operation - Jensen JDV8035 Installation And Operation Manual

JDV8035
MIDDLE
Middle (Level)
User has 5 seconds to use the encoder volume knob to adjust the desired Middle level
range from -6 to +6.
Middle-CFQ (C.Frq)
User has 5 seconds to use the encoder volume knob to adjust the desired Middle Range
Center Frequency to 500Hz, 1KHz, 1.5KHz, or 2.5KHz.
Middle-Q (Mid-Q)
User has 5 seconds to use the encoder vlome knob to adjust the desired Middle Quality
Factor to 2N, 1N, 1W or 2W.
Figure 2 shows the middle Quality factor (Curve characteristics) of each step.
15
10
5
Level
(dB)
0
10 100 1.10
Frequency (Hz)
TREBLE
Treble (Level)
User has 5 seconds to use the encodr volume knob to adjust the desired Treble level range
from -6 to +6.
Treble CFQ (Freq)
User has 5 seconds to use the encoder volume knob to adjust the desired Treble center
frequency to 10KHz, 12.5KHz, 15KHz, or 17.5KHz.
BALANCE
User has 5 seconds to use the encoder volume knob to adjust the Balance between the
right and left speakers from R12 (full right) to L12 (full left). "C00" represents an equal
balance between the right and left speakers.
FADER
User has 5 seconds to use encoder volume knob to adjust the Fader between the front and
rear speakers from R12 (full rear) to F12 (full front). "C00" represents an equal balance
between the front and rear speakers.
1N
1W
2W
2N
5
3 4 1.10
1.10
Figure 2

13. TUNER OPERATION

19) BAND BUTTON (BAND)
Press BAND to change between FM bands and AM(MW) bands.
20&21)TUNING UP/DOWN BUTTON (
Manual Tuning
Press the Up Tuning( ) or Down Tuning (
radio frequency number up or down by one step.
Auto Seek Tuning
Press the Up Tuning ( )or Down Tuning (
next station automatically.
12~17)PRESET STATIONS BUTTONS
Six numbered preset buttons store and recall stations for each band.
11)AUTOMATICALLY STORE / PRESET SCAN (AS/PS)
Automatically select 6 strong stations and store them in the current band. Select a band (if
needed). Press AS/PS button for more than three seconds. The new stations replace stations
already stored in that band.
Preset Scan
Scan stations stored in the current band. Select a band (if needed). Press AS/PS button for less
than 3 seconds. The unit will pause for ten seconds at each preset station. Press AS/PS button
again to stop scanning when the desired station is reached.
STEREO
The unit will automatically pick up a stereo signal when available. When in stereo mode, the ST
icon appears in the display. When no stereo signal is available, the unit will automatically revert
to mono operation, and no icon will be displayed.
E - 11
/ )
)button for more than 3 seconds to move the
)button for less than 3 seconds to move to