Specification; Troubleshooting - Jensen JDV8035 Installation And Operation Manual

JDV8035

21. Specification

TFT Screen Section
Screen Size: 3.5" (Measured Diagonally)
Screen Type: TFT Liquid Crystal Display active matrix
Resolution: 960 (W) x 324 (H)
DVD / CD Section
See " Disc Note" for more details description
Compatible Disc/Format
> 90 dB
Signal to Noise Ratio
> 9 0 dB
Dynamic Range
20Hz to 20Khz +/-3dB
Frequency Response
Channel Separation 2 Channel (Stereo) >60dB @1khz
Video Section
NTSC / PAL
Color System
Composite 1.0 Vp-p (+/- 0.2) 75 - ohm
Video Output
Composite 1.0 Vp-p (+/- 0.2) 75 - ohm
Video Input
Audio Section
Max Output Power
40W x 4 channels
Load Impedance (speakers)
4 ohms
Digital Output 900mV
Line out level / load 400mV / 10k ohm load
Line out Impedance 200 ohm
Auxiliary Input Section
Frequency response 20Hz to 20KHz -3dB
Input Maximum Voltage 1200 mV
Input Impedance 4.7k ohm
Radio Section
FM
87.5-107.9 MHz (200 kHz Space)
Frequency Range
Usable Sensitivity < 15dB at S/N 30 dB
Stereo Separation
25 dB at 1KHz
S/N Ratio
50 dB
AM or MW
Frequency Range
530-1720 (10 kHz Space)
Usable Sensitivity
< 40dB at S/N 20dB
S/N Ratio
40 dB
General
Operating Voltage DC 11 -14.4V
Grounding System Negative Ground
Fuse: 15-Amp Mini ATM Type
Operating Temperature: 0 C to 50 C
Unit Mounting Angle < 30
22. TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems persist
after check list has been made, consult your nearest service dealer.
Symptom
Cause
The car ignition is not on.
No power
The fuse is blown.
Presence of CD disc inside
Disc cannot be
the player.
loaded or ejected
Inserting the disc in reverse
direction.
Compact disc is extremely
dirty or defective disc.
Temperature inside the car is
too high.
Condensation.
Volume is in minimum.
No sound
Wiring is not properly
connected.
The built-in microcomputer is
The operation keys
not operating properly due to
do not work
noise.
The installation angle is
Sound skips.
more than 30 degrees.
The disc is extremely dirt or
defective disc.
The radio does not The antenna cable is not
work. connected.
The radio station
automatic selection The signals are too weak.
does not work.
Mechanism Error
ERROR
Disc Error
Maybe disc dirty / disc scratched
/disc upside down.
E - 23
Solution
If the power supply is properly connected
to the car accessory terminal, switch the
ignition key to "ACC"
Replace the fuse.
Remove the disc in the player, then
put a new one.
Insert the compact disc with the
label facing upward.
Clean the disc or try to play a new one.
Cool off or until the ambient temperature
returns to normal.
Leave the player to off for an hour or so,
then try again.
Adjust volume to a desired level.
Check wiring connection.
Press the RESET button.
Front panel is not properly fixed into
its place
Adjust the installation angle to less
than 30 degrees.
Clean the compact disc. Then try to play a
new one.
Insert the antenna cable firmly.
Select a station manually.
Press the eject button to correct the problem.
If the error code does not disappear, consult
your nearest service dealer.
Replace the disc.