Keyboard - NEC VERSA V User Manual

Drive options include the following:
IDE Hard Disk Interface
Allows you to select the internal IDE controller, the
docking station's IDE controller if the system is docked,
or to disable the interface completely.
Diskette Boot
Lets you specify from which drive you would like the
system to boot. When disabled, prevents boot-up from
the diskette drive. When enabled, allows start-up from
the diskette drive. If a diskette is not inserted in drive A
or drive A isn't installed, the system defaults to drive C.

Keyboard

The Keyboard option (
board parameters and set password options. The following
information describes the parameters.
Typematic Rate
The typematic rate is the speed at which a key repeats it-
self when you press the key. Use this parameter to
change the rate to suit your typing speed.
Numlock Boot Status
This controls the Numlock key status at power-on.
When set to "Numlock Off" (the default), this parameter
disables the Numeric Keypad mode at power-on. Set this
parameter to "Numlock On" to enable the Numeric
Keypad mode at power-on.
System Password
You can use this parameter to enable and set a system
password for system security. The system password
protects your data by allowing your system to boot only
after you enter a password. You are not prompted for a
password until you set an initial password.
Once you set a system password, you can enable the
keyboard lock hot keys.
Alt-K ) lets you check or change key-
Using Auto Setup 5-9