Table of Contents
Advertisement
6.
Locate the memory module sockets. Your system comes with one
module already installed in the socket. When installing additional
memory, use the other empty socket.
Avoid touching the exposed components inside the
system. Doing so can damage the system.
Align the notch with the notch in the socket connector and insert the
7.
module as follows.
T
Hold the SO-DIMM at a 30-degree angle and align the SO-
DIMM connector with the socket in the system. Push the
connector into the socket.
T
Press down on the edge of the SO-DIMM until the locking tabs
on the sides snap into place, securing the module.
To remove a SO-DIMM, press the locking tabs away from the sides
of the module until the module pops up. Then, remove the SO-
DIMM.
Reassemble the NEC Versa Note components as follows.
8.
T
Replace the Memory Module Bay cover.
T
Replace the screw.
T
Turn the system over.
T
Rebuild your PHDisk Save-to-Disk file as described in
Chapter 2.
CAUTION
Using Your NEC Versa Note 4-21
Advertisement
Table of Contents
