GFI System SOLIS VENTUS User Manual page 21

Options
Spillover
Off
This option DOES NOT set the actual spillover time, rather, it sets the maximum
length of time the tails from previous preset may spillover into the new preset sound.
For example, if you are switching from a preset that was running a reverb with over
20 second decay, then setting the spillover option value to 8.0s will reshape the tail
such that the it decays out in 8 seconds instead. On the other hand, if the reverb was
set for < 4 second decay, the tail will simply decay out after 4 seconds.
This spillover time control is useful in situations where you use a delay or reverb with
a very long repeats or decay setting in a song, but do not want that endless tail to last
for so long during preset/song change.
DSP X Trails
DSP Y Trails
PC Call State
Preset Title
Exp1 X Setup
Exp1 Y Setup
Exp2 X Setup
Exp2 Y Setup
: No spillover when switching from this preset to another.
: Spillover is capped to 0.5 seconds.
0.5s
: Spillover is capped to 1 seconds.
1.0s
: Spillover is capped to 2 seconds.
2.0s
: Spillover is capped to 4 seconds.
4.0s
: Spillover is capped to 8 seconds (default).
8.0s
: Spillover is capped to 16 seconds.
16.0s
: Spillover time is unbounded.
Inf.
: The wet signal cuts out immediately when DSP X is bypassed.
Off
: The wet signal fades out when DSP X is bypassed.
On (default)
: The wet signal cuts out immediately when DSP Y is bypassed.
Off
: The wet signal fades out when DSP Y is bypassed.
On (default)
: Pedal is engaged when preset is called via PC (MIDI).
Engaged (default)
Bypassed : Pedal is bypassed when preset is called via PC (MIDI).
: Edit the title of the current preset.
: Enter menu for setting up
: Enter menu for setting up
: Enter menu for setting up
: Enter menu for setting up
Expression-1 to DSP X
Expression-1 to DSP Y
Expression-2 to DSP X
Expression-2 to DSP Y
20
assignment and parameters.
assignment and parameters.
assignment and parameters.
assignment and parameters.