NEC VERSA 6050MH Service Manual page 71

2-28 Setup and Operation
T
Drives
The drives parameter let you check and change settings for your drives, including
internal hard drives, diskette drives, and CD-ROM reader. This parameter also
lets you check the docking station's hard drives, diskette drives, and CD-ROM
reader when the system is docked.
Advanced CMOS Setup
Sets CMOS settings for the following functions.
T
BootUp Sequence
Sets the order that the drives (A:, C:) initialize, or sets the order to search for the
boot disk.
T
Plug and Play Aware O/S
Selects whether or not the system boots to a Plug and Play operating system.
T
NumLock (at Boot)
Selects NumLock On or Off at system startup.
T
Keyboard Auto-repeat Rate
Selects repeat key speed.
T
Keyboard Auto-repeat Delay
Selects repeat key speed delay.
T
Password Check
When the system prompts you to enter a password, the password is verified.
Power Management Setup
The Power Management Setup menu lets you balance high performance and energy conser-
vation using parameters including the following.
T
Power Management Under AC
Normally, whenever AC power is connected to your NEC Versa system, power
management is disabled. If you enable this parameter, the system automatically
activates the power management profile you set.
NOTE: Some operating systems such as Win-
dows for Workgroups and Windows 95 have
their own power management software which
overrides CMOS settings. In this case, be sure to
set your desired power management settings ac-
cordingly.