NEC VERSA 6050MH Service Manual page 70

PARAMETER
Change Supervisor
Password
Enter new supervisor
password, retype
supervisor password.
Auto Configuration with
Defaults
At prompt, press Y or N to
load/cancel default settings.
Save Settings and Exit
At prompt, press Y or N to
save/cancel current
settings.
Exit without Saving
At prompt, press Y or N to
quit without saving
current settings.
Selectable only when notebook is docked.
*
Setup Menus
Read the following descriptions for an explanation of each item that appears in the Setup
menus, as listed in the preceding table.
Standard CMOS Setup
When you select the Standard CMOS Setup screen you will see System Time and System
Date parameters as well as drive parameters.
T
Date/Time
Lets you set your NEC Versa's calendar month/year and system clock. The calen-
dar clock is year 2000 compliant. These settings remain in memory even after you
turn off system power.
To set the time, enter the current hour, minute, and second in hr/min/sec, 24-hour
format. Use the Tab key to move from field to field. Use the PgUp or PgDn key
to change the numbers within each field.
To set the date use the Tab key to move from field to field. Use the PgUp or
PgDn key to change the numbers within each field.
Table 2-8 Setup Parameters
DEFAULT
SETTING
Not Applicable.
Not Applicable.
Not Applicable.
Not Applicable.
Setup and Operation
ALTERNATE
SETTING(S)
Not Applicable.
Not Applicable.
Not Applicable.
Not Applicable.
2-27