Post Errors; Post Error Messages - NEC VERSA 6050MH Service Manual

T
The electrical outlet is working.
T
The brightness and contrast controls for the display are adjusted properly.
T
All options have been properly installed.

POST Errors

Error messages will appear during POST when configuration information does not match
the settings stored in memory. Error message will also appear if the system loses the con-
figuration information due to hardware failure.
Refer to Table 2-4 for a description of POST error messages.
MESSAGE
Diskette drive A or B
failure or No Floppy
Drive
Invalid system disk
Diskette boot failure
Non-system disk or
disk error; Replace
and press any key
when ready
Operating System
Not Found
or
C: drive failure
NOTE: If the system parameters (date, time,
options, etc.) have not been entered for the pres-
ent configuration, enter them when you complete
the setup procedures (see "System Parameters"
in this section).
Table 2-4 POST Error Messages
WHAT TO DO
Drive A does not work or is not properly
connected. Drive A is the diskette drive.
Check that drive A is securely connected and
power is on.
Press
F2
drive parameters.
If there's still a problem, the drive might need
repair.
Replace the disk and then press any key.
Insert a bootable disk in drive A and press any
other key.
Remove the diskette from drive A and press
any key to start the system from the hard disk.
Or, insert a bootable disk in drive A and press
any key.
Press
F2
disk type to the correct setting. Exit and save
Setup changes.
Setup and Operation
to start Setup to check the diskette
to start Setup. Change the hard
2-19