Table of Contents
Advertisement
2-26
Setup and Operation
Setting incorrect values in the Advanced portion of the Setup utility
can result in a system malfunction.
T
Integrated peripherals — lets you disable, enable, or manually change COM port
and LPT port address and mode. You can also define the audio I/O address, MIDI
port address, audio IRQ number and DMA channel.
T
Plug & Play OS — displays whether the operating system on your NEC Versa is
plug-and-play operating system.
T
Large Disk Access Mode — allows you to specify the large disk access mode to
use.
Security
Your NEC Versa 5000 supports a password for system security. Using the Security screen,
you can require that a password be entered at each startup or boot.
You are not prompted to enter a password until you set an initial password. Your system is
not protected until you set a password.
NOTE
plemented, the user level cannot access the diskette
drive.
Once you set a password, you must enter it before your system will boot up. This feature
allows only an authorized user to access your system, including the Setup program where
you can set or change system parameters.
Set an initial password as follows.
Select Security from the menu bar.
1.
Open the Set Supervisor Password screen by pressing
2.
In the "Enter New Password" field, enter a password up to eight characters long.
3.
Press
on the keyboard.
Enter
Reenter your password as prompted for verification. Press
4.
password down and keep it in a secure place in case you forget it.
A dialog box notifies you that changes have been saved. Press
"Supervisor Password is" field changes to Enabled. This password keeps anyone
without the password from making changes in Setup.
!
If Supervisor and User passwords are both im-
CAUTION
.
Enter
Enter
and write your
to continue. The
Enter
Advertisement
Table of Contents
