Setup Utility - NEC VERSA 5060 Service Manual

2-18 Setup and Operation
Hard Disk controller
failure
Keyboard controller
failure
Keyboard Error
KB\interface error

SETUP UTILITY

The Setup utility is a ROM-based program. It is functional when enabled (factory default).
Setup automatically detects current system parameters during the power-on self-test
(POST), described in the previous section. It also provides the following functions:
T
sets date and time
T
signals any hardware discrepancies during POST via error messages
T
verifies that any optional memory that you installed was installed correctly
T
integrates user defined security features.
Press F2 to start Setup. Exit and save to update
the parameters.
Check to see if the hard disk connector is
seated properly.
The hard disk controller does not work and
might need repair.
Unplug external keyboard if attached and reboot
the system. If it still fails, have the system
repaired.
NOTE
Repeated keystrokes during boot may
produce an error message .
A timing problem exists with the keyboard. If the
error message remains, the keyboard may have
to be repaired.
Error exists in keyboard connector. If the error
message remains, the keyboard may have to be
repaired.
NOTE
If a display related error occurs it is indi-
cated by beeps. Display related errors usually
require a system board replacement.