Printer; Parallel Devices - NEC VERSA 4000 Manual

4. Connect the monitor power cable and plug it into a
properly grounded wall outlet.
5. Follow any setup instructions in the monitor manual.
6. Turn on power to the monitor.
Press the Suspend button to resume Active mode or
7.
power on the NEC Versa 4000.
Press the
tween the LCD, CRT, or simultaneous display on both.

Printer

You can attach a printer with either a parallel or a serial
connector. A parallel printer connector has 25 pins; a serial
connector has 9 pins. Some printers come with both types
of connectors.

Parallel Devices

To install a parallel device, such as a printer, you need a
cable with a male 25-pin connector for the system and, for
most parallel printers, a Centronics®-compatible 36-pin
connector.
NOTE
the appropriate printer driver through the Windows
Control Panel.
Connect a parallel device to your NEC Versa 4000 as
follows.
1. Check that both the NEC Versa and parallel device
power are off.
Fn + F3 function key combination to toggle be-
When you connect a printer, be sure to install
Using the Hardware 2-23