Bush H236V6D Instruction Manual page 17

Getting to know your TV
You'll be up and running in no time
Aerial connection
Connect a coaxial cable (not provided) to the ANT/
CABLE IN jack on the back of your TV and to the
antenna or cable TV wall jack.
Connect the incoming cable from the cable wall jack to
the cable-in jack on the cable or satellite box. Connect
a coaxial cable (not provided) to the ANT/CABLE IN jack
on the underside of your TV and to the coaxial out jack.
on the cable or satellite box.
Power connection
Connect the power cord plug to the mains power
socket.
Please note: After unpacking, allow the TV
to reach ambient room temperature before
connecting the TV to the mains power socket.
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 604 0105.
Remote controls - Inserting batteries
Remove the battery cover on the back of the TV remote
control, gently push down and pull backwards at the
same time as shown .
Remove the battery cover on the back of the DVD
remote control, Pull the clip on the back battery,and
lift the battery cover away at the same time as shown.
Insert two AAA/R3 or equivalent type batteries. Ensure
the batteries are inserted the correct way and replace
the battery cover.
Note: When the remote control is not going to be
used for long periods of time, the batteries should
be removed. Otherwise the remote control may be
damaged, caused by battery leakage and corrosion.
Aerial or Cable
Switching the TV On and O
Switching the TV On
With power cord plug connected to the mains power
socket and TV in 'Standby' mode.
To switch the TV on from standby mode, either:
a: The Remote control; Press the " " button.
b: The TV; Press the " " button on the back of the TV.
Switching the TV O
Either press the " " button on the TV remote control or
press the " " button on the back of the TV, the TV will
then switch to standby mode.
AAA/R3 X 2
Batteries
Getting to know your TV
AAA/R3 X 2
Batteries
17