Bush H236V6D Instruction Manual page 13

Getting to know your TV
You'll be up and running in no time
Installing / Removing the Feet
Feet Assembly Instruction
the TV and feet both have Left and Right symbols
1. Lay the TV flat on a table with the LED screen face
down. To prevent the TV from being scratched, put a
piece of soft cloth on the table on which the screen
will be set.
2. Place the feet in position as shown. Insert and tighten
4 screws (provided) into pedestal holes as shown.
R
INSTALLATION NOTES
This TV can be connected to an AC 100-240 Volts,
50/60 Hz power supply. Never connect straight to a DC
power supply.
Locate the TV in a room where light does not strike the
screen directly. Total darkness or a reflection on the
screen can cause eyestrain. Soft and indirect lighting is
recommended for comfortable viewing.
Allow enough space between the TV and the wall to
permit ventilation.
Avoid excessively warm locations to prevent possible
damage to the cabinet or premature component failure.
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 604 0105.
L
Wall Mounting Installation Guidelines
1. Lay the TV flat on a table with the LED screen face
down. To prevent the TV from being scratched, put a
piece of soft cloth on the table on which the screen
will be set.
2. Remove the 4 screws .
3. Remove the feet.
4. Use the four screws (M4*6mm,not included) to fix the
TV onto a wall mounting bracket (not included) via the
four VESA standard holes on the back of the television.
100x 100 mm VESA mount
Getting to know your TV
13