Bush H236V6D Instruction Manual page 18

Getting to know your TV
You'll be up and running in no time
Operation using remote control
The remote control is designed to control all the TV
functions.
Volume Setting
Press VOL+ button to increase the volume.
Press VOL- button to decrease the volume. A volume
level scale (slider) will be displayed on the screen.
Programme Selection (Previous or Next Programme)
Press CH- button to select the previous programme.
Press CH+ button to select the next programme.
Programme Selection (Direct Access)
Press number buttons on the remote control to select
programmes between 0 and 9. The TV will switch to the
selected programme.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
18
Getting to know your TV
How to watch a DVD
1.Press the " " button on the TV or remote control.
2.Switch to DVD source using the "INPUT" button on the
remote control.
3.Insert a disc into the loader.
The no label side of the disc MUST be facing you when
looking at the TV screen.
Note：Only use fixed outer diameter 120mm disc,
use other size disc may cause card disc!
Label side
If play does not start automatically, press the "
on the DVD remote control, or the " 
back of the TV.
A menu may appear on the TV screen after a few
moments or the film may start immediately after the
Film/TV Company introduction. This will depend on the
disc content and may di er on each disc.
Steps 4 and 5 are only available when a menu is
recorded on the disc.
4. Press the navigation buttons "
buttons to select the required title.
5. Press the OK button. The selected item starts to play.
Label side
II
"button
II
" button at the
" or the number
