1. Manuals
  2. Brands
  3. Make Noise Manuals
  4. Recording Equipment
  5. BRUXA
  6. Manual

Make Noise BRUXA Manual

Hide thumbs

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BRUXA and is the answer not in the manual?

Questions and answers

Related Manuals for Make Noise BRUXA

Summary of Contents for Make Noise BRUXA

  • Page 2: Table Of Contents

    TABLE OF CONTENTS 1. LIMITED WARRANTY 2. INSTALLATION 3. INTRODUCTION 4. PANEL CONTROLS 5. HISTORY 6. PATCH IDEAS...

  • Page 3: Limited Warranty

    LIMITED WARRANTY Make Noise warrants this product to be free of defects in materials or construction for a period of one year from the date of purchase (proof of purchase/invoice required). Malfunction resulting from wrong power supply voltages, backwards or reversed eurorack bus board cable connection, abuse of the product, removing knobs, changing faceplates, or any other causes determined by Make Noise to be the fault of the user are not covered by this warranty, and normal service rates will apply.

  • Page 4: Installation

    Eurorack style bus board, minding the polarity so that the RED stripe on the cable is oriented to the NEGATIVE 12 Volt line on both the module and the bus board. On the Make Noise 6U or 3U Busboard, the negative 12 Volt line is indicated by the white stripe.

  • Page 5: Introduction

    While Strega is a complete synthesizer in a tabletop form factor, Bruxa is a Eurorack module designed to be used as one part of a Eurorack modular synthesizer. You will discover a number of differences in layout, signals, and sound.

  • Page 6: Panel Controls

    PANEL CONTROLS 1. Signal Input: Signal Input 2. Input Level Panel Control: Sets the level of the incoming signal at the Signal Input. 3. Blend CV Input: Control voltage input for Blend. 4. Blend Combo Pot: Blends between the Signal Input and the Time/Filter experiment (aka Dry/Wet Mix).
  • Page 7 PANEL CONTROLS 1. Decay CV In: Direct coupled CV input for Decay. 2. Decay Panel Control: Sets the iterations of Time/Filter experiment. Ranges from a handful to infinity. 3. Filter: Removes unwanted substance from the results of Time/Filter experiment. 4. Filter CV Attenuverter: Bipolar attenuator for Filter CV In. 5.

  • Page 8: History

    HISTORY Elements of Bruxa will be familiar if you have used Strega, but the two instruments have each taken a unique development path from the prototype circuit that is their common ancestor. Strega’s Time/Filter experiment became thoroughly merged with and tuned to the circuits that would become the Strega Tones and its integra- tion with line level instruments, whereas Bruxa’s Time/Filter experiment is designed to intermingle more...

  • Page 9: Patch Ideas

    PATCH IDEAS Wow & Flutter Sound Source -> Signal Input. CV Out -> Time CV In. Set Time panel control and CV attenuverter to 12:00, then adjust slightly to taste. Slower times are more “tape-like” but also potentially noisier. Noise Mult Output to Monitor, and also to Signal Input.

Table of Contents