Checking Differences Between Cmos Setup Defaults And Shipped Settings; From The Standard Cmos Setup Menu; From The Pnp/Pci Configuration Menu - NEC POWERMATE ES 5250 - RELEASE NOTES Release Note

6. Repeat steps 4 and 5 to remove the
7. In the Configuration tab display, click
.
Add
8. Highlight
window appears. If there is a DHCP server on the network, click
otherwise click
9. Change the path in the window to
window appears. If Yes was clicked in step 8, skip to step 16. If No was
clicked in step 8, the Windows Setup window appears.
10. Click
Close
11. Fill in the
"Specify an IP address" area.
12. Click the
13. Click the
14. Click the
15. Click the
16. Click
OK
Checking Differences Between CMOS Setup Defaults and Shipped
Settings
The CMOS settings as shipped for your system might differ from the default
settings. If the Setup Defaults are loaded, and depending upon your system
configuration, it might be necessary to adjust certain CMOS settings to recreate
the shipped BIOS settings.
You can find information about entering CMOS Setup in Chapter 3 of the
PowerMate ES 5250 Series User's Guide. It is recommended that you write
down the current settings before making any changes.
If the default settings are loaded, either manually or because of a dead CMOS
battery, you might need to change some of the settings. Check the settings
described in the following sections.

From the Standard CMOS Setup Menu

"Drive A" defaults to "1.44M, 3.5IN." If the system is using the optional LS120
120-MB SuperDisk Drive, or the system is not using a diskette drive, set
Drive A to "Disabled."

From the PNP/PCI Configuration Menu

"PNP OS Installed" defaults to "Yes." If the system is using the Windows NT
operating system, change this setting to "No."
8 NEC PowerMate ES 5250 Series Release Notes
and then
Microsoft TCP/IP
.
No
. The Microsoft TCP/IP Properties Box appears.
, the
IP Address Subnet Mask
tab and enter the host and domain name in the DNS display.
DNS
tab and change the Computer Name if appropriate.
Identification
tab and enter the WINS address if appropriate.
WINS
Routing tab and enable IP forwarding if appropriate.
. When prompted to restart the system, click
Protocol.
NetBEUI
. Highlight
Add Protocol
and click . The TCP/IP Setup
OK
C:\I386 . Click Continue
, and the
Default Gateway
Yes
and click
Yes ;
. The Network
in the
.