Installing Cheyenne Backup; Installing Partitionmagic - NEC POWERMATE ES 5250 - RELEASE NOTES Release Note

If you interrupt the uninstall process or power off the system, you cannot use the
uninstall utility to remove the LANDesk application. You must then use the
NEC OS Restore CD to perform a full operating system restore. After the full
restore, you must reinstall all appropriate applications from the NEC
Application and Driver CD.

Installing Cheyenne Backup

After installing the Cheyenne
system, an "Unable to connect to Group" error message might be displayed.
This message indicates that a backup tape unit is not installed. Installing a tape
unit or reconfiguring the Cheyenne Backup utility removes this message.
See "Using Cheyenne Backup" for issues related to using the utility in
Windows 95.

Installing PartitionMagic

Install PartitionMagic™ files from the NEC Application and Driver CD. Select
the PartitionMagic software from the Applications tab in the Installation utility
menu. The utility loads files from the NEC Application and Driver CD to
C:\Program Files\PowerQuest\PartitionMagic4
documentation files in the following folders:
T
Btmagic
T
Diskette
T
Setup
T
Userinfo.
If the PartitionMagic setup program asks you for a serial number, enter the
following number:
PM400ENOEMCD-673785
See the documentation in the Userinfo folder for information about using
PartitionMagic, BootMagic™, and the recovery diskette program. Reading the
Userinfo files requires the Adobe
comes on the NEC Application and Driver CD. Select the Adobe software from
the Applications tab in the Installation utility menu.
Note:
the Windows NT operating system, see "Installing
BootMagic in a System with Windows NT" at the end of this
document.
®
Backup utility on the system and rebooting the
®
Acrobat Reader. The Adobe Acrobat Reader
If you are installing BootMagic in a system with
NEC PowerMate ES 5250 Series Release Notes 5
. You can find setup and