Advertisement
MODIFICATIONS TO THE PRODUCT
Radio Frequency Interference
The manufacturer is not responsible for any radio or TV interference caused by unauthorised modifications to
this equipment.
Safety Warning
The manufacturer is not responsible for any safety hazard caused by unauthorised modifications to this
equipment.
RADIO FREQUENCY INTERFERENCE STATEMENT
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This is a Class B Digital Device. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to CISPR22 Standard. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
There is no guarantee, however, that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measures.
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from the one to which the receiver is
connected.
To meet CISPR22 Standard, shielded cables and power cords are required when connecting this
device to a personal computer or other Class B certified device.
CONNECTIONS AND REMOTE EARTH
PELV (Protected Extra Low Voltage)
To ensure the extra-low voltage integrity of the equipment, only connect equipment with mains-protected
electrically-compatible circuits to the external ports.
SELV (Safety Extra Low Voltage)
Every input and output of this product is classified as Safety Extra Low Voltage, except the modem, which is
classified as TNV-3.
Remote Earth
To prevent electrical shock, connect all local (individual office) computers and computer support equipment
to the same electrical circuit of the building's wiring. If you are unsure, check the building's wiring to avoid
remote earth conditions.
Building Supply
Only connect the equipment to a building supply that is in accordance with current wiring regulations in your
country.
- 14 -
Advertisement
