Advertisement
Your computer is supplied with a backup partition on the hard disk drive which contains all data you may
need in order to restore your configuration as it was when leaving the factory. This partition occupies about
10 GB of your hard disk drive.
This backup partition is hidden.
The NEC Recovery Program can restore your computer to the same state as when you purchased it, while
giving you an option to retain all settings and personal data for later retrieval.
Due to the wide range of reasons for which the NEC Recovery Program may be used, no
guarantee can be given that all data will be retained.
The procedure described below is only applicable if your backup data is stored on your computer's hard disk.
If you wish to restore your computer using Recovery DVD, please see note below.
You are strongly recommended to create a set of Recovery DVD for future use.
Be ready with 2 blank DVD-R. Please use the MDVDCreator tool. Click on the icon at Start button
All Program – MDVDCreator
You are strongly recommended to create a set of Recovery DVD for future use.
Be ready with 2 blank DVD-R. Please use the MDVDCreator tool. Click on the icon at Start button
- All Program – MDVDCreator
process.
Before you run MDVDCreator program, you need to disable UAC (User Account Control). To do this,
go to Start button
Turn User Account Control on or off. Then uncheck the "Use User Account Control (UAC) to help
protect your computer". Click OK button.
to launch MDVDCreator program. It will guide you through the process.
to launch MDVDCreator program. It will guide you through the
- Control Panel - User Account and Family Safety - User Accounts -
-
- 19 -
Advertisement
