Table of Contents
Advertisement
T
Proxy — if using a proxy server, enter the name of the proxy
server. If the proxy server is set up to use a port other than port
8080, enter a colon (:) and the port number immediately
following the server name.
T
User Name — enter your user ID (as entered in the MobilePro
Synchronization System server).
T
Password — enter your user password (as entered in the
MobilePro Synchronization System server).
T
Confirm — enter the same password again to confirm it.
In the Clear History After box, type or select the number of days you
3.
want to keep the history.
4.
Tap
OK
to exit the Configuration screen.
If you want to set up Secure Sockets Layer (SSL) encryption for
passwords and authentication for iSM and iFD on your MobilePro, use
the following procedure. For this to work, SSL must also be set on the
MobilePro Synchronization System server.
1.
Power on your MobilePro.
At the Today screen, tap
2.
T
At the Navigation Bar, tap
T
At the MobilePro Sync System screen, tap
Software Distribution
screen is displayed.
3.
At the Connection screen, select the Enable SSL check box.
4.
Tap
OK
to exit the Connection screen.
Your MobilePro operating system has an autocomplete input feature that
might hinder the security of passwords. By default, this feature is enabled.
If enabled, when you begin to enter a password, suggested words are
displayed in a window above the input panel. A space might also be
added to the end of the suggested word. To disable this feature, perform
the following steps.
1.
Power on your MobilePro.
.
Start
MobilePro Synchronization System
Settings
, and tap
. The Connection
Connection
Getting Started Guide 41
.
, tap
File &
Advertisement
Table of Contents
