Charging The Battery - NEC MOBILEPRO P300 - QUICK GUIDE 2001 Quick Manual

Charging the Battery

Your MobilePro P300 contains a rechargeable Lithium Ion battery. The
battery must be charged before you use the MobilePro the first time and
periodically recharged thereafter. As the battery is rechargeable, you do
not need to constantly replace batteries.
Battery power is monitored by your MobilePro P300. Warning messages
and battery low icons display when battery power becomes low. If you
receive a battery low warning message, you should save your data and
recharge the battery as soon as possible to avoid data loss.
You can also monitor battery power activity through the power remaining
indicator on your MobilePro. Press or tap the My Menu button to see the
indicator. Or tap
Use the MobilePro cradle and AC adapter to charge the battery. You can
also directly charge the MobilePro using the AC adapter.
Note
Before using your MobilePro for the first time, you need to charge
the battery. Do not use the MobilePro until the battery is fully charged, as
indicated by the steady green battery charging LED and the power
remaining indicator.
Charge the battery as follows.
1. Position the cover so that it does not cover the back and front of the
MobilePro.
2. Plug the MobilePro into the cradle.
3. Plug the AC adapter cable into the power port on the back of the
cradle (see the following figure).
If you are not using the cradle, plug the cable directly into the power
port on the bottom of the MobilePro.
Start , tap Settings , tap the System tab, and tap Power
Getting Started Guide 13
.