Related Manuals for HOLT HI-1592
Summary of Contents for HOLT HI-1592
- Page 1 HI-1592 Rad Hard MIL-STD-1553 Evaluation Board Quick Start Guide Devices Supported HI-1592 August 2024 QSG-1592_New Holt Integrated Circuits...
- Page 2 REVISION HISTORY Revision Date Description of Change Rev. New 8/19/2024 Initial Release QSG-1592_New Holt Integrated Circuits...
- Page 3 Introduction This evaluation board demonstrates the operation of the HI-1592. The HI- 1592 is a radiation hardened MIL- 1553 transceiver. The kit is composed of a HI-1592 and associated circuitry to support FPGAs or driverless MIL- 1553 protocol controllers. This guide describes how to set up and run the board.
-
Page 4: Evaluation Kit Contents
• Default Jumper Settings The HI-1592 evaluation board image above shows the default positions and settings of the jumpers and switches. Those settings are also described in the table below. The table sorts the switches and jumpers from top left to bottom right. -
Page 5: Hardware Design Overview
Initial Kit Setup • Connect a MIL-1553 protocol controller (FPGA or ASIC) to either J20 or J16. • Power up both the protocol controller board and the EVB board simultaneously. Apply test signals to demonstrate operation. • QSG-1592_New Holt Integrated Circuits... -
Page 6: Demonstration Images
BUSA digital transmit input signals. RXp and RXn are connected to the digital receive outputs of BUSB. The BUSp signal shows the signal present on BUS B. Board Files and Schematic Links BOM and Schematic Files: EV-1592 QSG-1592_New Holt Integrated Circuits...
Need help?
Do you have a question about the HI-1592 and is the answer not in the manual?
Questions and answers