Dell PP01S User Manual page 38

Dell Diagnostics: Dell Latitude LS Portable Computers User's Guide
In the system setup program, go to the
4.
1. Removable Devices
2. ATAPI CD-ROM Drive
3. Hard Disk
4. Boot to LAN
5. Save the changes and exit the system setup program.
6. Insert the Dell System Software CD into the CD-ROM or DVD-ROM drive.
Turn the computer off.
7.
Turn the computer on. The computer restarts and automatically begins to run the Dell Diagnostics.
8.
When you have completed running diagnostics, remove the Dell System Software CD from the CD-ROM or DVD-ROM drive.
9.
To return to the boot sequence you use for normal operation, repeat steps 1 through 5, customizing the boot sequence to fit your
needs. Then restart your computer.
When you start the diagnostics, the Dell logo screen appears, followed by a message telling you that the diagnostics is loading.
After the diagnostics loads, the Diagnostics Menu appears (see
or to exit to the MS-DOS® prompt.
For a quick check of your computer, select Quickly Test All Devices. This option runs only the subtests that do not require user
interaction and that do not take a long time to run. Dell recommends that you choose this option first to increase the odds of tracing the
source of the problem quickly. For a thorough check of your computer, select Fully Test All Devices. To check a particular area of your
computer, select Select Devices to Test.
To select an option from this menu, highlight the option and press <Enter>, or press the key that corresponds to the highlighted letter in
the option you choose.
Figure 1. Diagnostics Menu
Dell Diagnostics Main Screen Overview
When you select Select Devices to Test from the Diagnostics Menu, the main screen of the diagnostics appears (see
main screen lists the diagnostic test device groups, lists the devices of the selected device group, and allows you to select categories
from a menu. From this screen, you can enter two other types of screens.
Information on the main screen of the diagnostics is presented in the following five areas:
Two lines at the top of the screen identify the version number of the Dell Diagnostics.
On the left side of the screen, the Device Groups area lists the diagnostic test groups in the order they will run if you select All
from the Run tests menu. Press the up- or down-arrow key to highlight a test device group.
On the right side of the screen, the Devices for Highlighted Group area lists the computer's currently detected hardware and
some of the relevant settings.
The lower-right side of the screen displays information about your drive(s).
file:///C|/Documents and Settings/Administrator/De.../New Web/Documentation/LS/LS User's Guide/diag.htm (2 of 4) [5/31/2000 9:45:31 AM]
Boot screen and set the following boot sequence:
Figure 1). The menu allows you to run all or specific diagnostic tests
Figure 2). The