Reece memo Hugo 2402868 Installation Instructions

Granite sink

Download this manual

Components Supplied

Granite Sink x1

Fixing Clip x8

Tools Required

Silicone

Drill x1

Prior To Installation

Examine the sink for any visible defects or imperfections. Do not install if any defects are found. If wall mounted

tapware is to be used, consideration should be made for the length of outlet and positioning of the sink on benchtop. If

tapware is to be bench mounted, allow suitable top width for fitting tapware. Both inset and undermount cut-out

templates are provided, please ensure the correct one is used for the appropriate installation method. Templates are

supplied only as a guide. Be sure to refer to the physical sink for accurate measurements of the countertop cut-out

hole. Template must be checked against the sink before installation. Any deviation from the template made to the cut-

out must ensure the installation integrity is still met.

Important

When Installing consider the bench top material or any obstructions that may impede sink

installation.

Plumbing connections must be installed to the requirements of AS/NZS 3500 by a qualified plumber. Modifying

Important

the product

outside of the information in the installation instructions is not

covered under warranty.

Memo Hugo Granite Sink

Inset Template x1

Undermount Template x1

Hole saw Ø35mm x1

Waste x1

is not recommended and will not be

Page 01

of 03

Need help?

Do you have a question about the memo Hugo 2402868 and is the answer not in the manual?

Page 1 Memo Hugo Granite Sink Components Supplied Granite Sink x1 Fixing Clip x8 Inset Template x1 Undermount Template x1 Waste x1 Tools Required Silicone Hole saw Ø35mm x1 Drill x1 Prior To Installation Examine the sink for any visible defects or imperfections. Do not install if any defects are found. If wall mounted tapware is to be used, consideration should be made for the length of outlet and positioning of the sink on benchtop.
Page 2 Tap Hole Cut Out • Flip Sink over and locate the two half-drilled holes. Ensure the Right Hand Bowl top of the Sink surface is kept free from being damaged • Select hole to install the tap and use a power drill with a Ø35mm hole-saw (without drill bit fitted) at its lowest speed to drill out the remainder of the material.
Page 3 Tap Hole Cut Out Note: Ensure correct Template is selected prior to Inset Template Undermount Template positioning. • Use Template provided (check the template against the Sink to be installed) then trace and cut out the benchtop. • Position the inset template on the benchtop surface and trace the cut line with a pencil.