Reece ISSY GLIDE 750 Installation Instructions Manual

ISSY
GLIDE VANITY UNIT
FEATUREs
Basin Type
Basin Configuration
Door/Drawer Design
Number of Drawers
Taphole
Configuration
mounting
Vanity Top
Features
Custom sizes
sPECIFICATIoNs
Height
Width
Length
other size options
Colour Variations
Fixing
Vanity Unit material
CLEANING RECommENDATIoNs
Open Sky Design vanity tops are a high grade acrylic Solid Surface with a semi gloss finish. It is recommended that this Solid
Surface top is protected during installation.
Your vanity should be cleaned with a mild, non acidic, non abrasive detergent and soft cloth. Finish by cleaning off detergents
with a soft damp cloth and towel dry. Always clean spills and water as they occur.
The Solid Surface top should be cleaned using a soft damp cloth with warm water OR a non abrasive ammonia based
household cleaner OR a dedicated counter top cleaner. The possibility of concentrated acidic ingredients present in some
beauty and cleaning products may damage the surface if left for a long duration. Citrus or silicone based sprays or polishes
should not be used . It is recommended that all spills are cleaned up as they occur.
Abrasive cleaners should NOT be used on this semi gloss surface. Damage caused by any improper treatment is not covered by
the product warranty.
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from
their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs
listed are correct at time of publication however the manufacturer/distributor takes no responsibility for
printing errors.
Tech Page Version 3
One Piece Intergrated Top and Basin
Left Hand Basin or Right Hand Basin
Push to Open or Sensor (powered)
750 1 Drawer
1200 2 Drawer
1500 2 Drawer
1750 4 Drawer
0 or 1 Taphole
Wall Hung
White Only Solid Surface Moulded Top And Basin
Movable Solid Surface Drawer Divider
Removable and Washable Non Slip Drawer Mat
Choice of Metallic Colours
Option of Sensor Powered Drawers
Solid Surface Moulded Waste Cut Out in Basin
Drawer
A Range of Customised Sizes Available
300mm For Glide 750, 1200 and 1500
320mm For Glide 1750 (double basin)
500mm
750mm, 1200mm, 1500mm (single basin) or
1750mm (double basin)
750 Single Drawer Can Be Customised 751 - 850mm
1200 2 Drawer Can Be Customised 1000 - 1300mm
1500 2 Drawer Can Be Customised 1400 - 1499mm
1750 4 Drawer, Double Basin Can Be Customised
1751 - 2000mm
Satin or Gloss (White)
Metallic Silver Gloss or Metallic Charcoal Gloss
Oak drawer fronts with matte clear finish, satin white
base and end panels
Bolted / Screwed to Wall by a Licensed Trades
Person
2 Pack Polyurethane on HMR MDF
To see the complete ISSY range go to
www.reece.com.au/bathrooms
by OPEN SKY DESIGN
page 1 of 6